When you download the 3D Lace and Organza Bell design, you will find multiple files. Some are the embroidery files, and the others are dieline files marked with the letters "DL". Dielines are used to cut the fabric to the correct shape and size. Open and print each dieline file using an embroidery software. If you do not have an embroidery software, take a look at our helpful video on using dielines.

Spray the backside of the front dieline printout with temporary adhesive and smooth it on top of the fabric.

Cut out the shape and repeat to make the back dieline piece. After cutting, make sure to fold up one corner of the paper dieline to make it easier to remove later.

Lace organza designs have been specially digitized for watersoluble stabilizer. After the stabilizer is removed, beautiful lace and organza remains. 

There are a couple of different kinds of water-soluble stabilizer. One is clear and plastic, and that brand is Sulky Ultra Solvy. The other is soft and fibrous, called Vilene. Both will work very well. Vilene is used in this demonstration. Use a size 11 or 75/11 sharp sewing needle. A sharp sewing needle has a smaller, finer point than an embroidery needle. That means it will make smaller holes in the stabilizer.

Organza lace is seen from both sides, so wind a bobbin with the same thread that you're using in the needle.

Hoop the stabilizer firmly. Make sure it is nice and tight with no wrinkles.

Load the embroidery file onto the machine (not the dieline), and embroider the design. The first thing to embroider will be a dieline, or outline stitch. This marks the area on the stabilizer where we'll place the front fabric piece.

Spray the back of the front piece with temporary adhesive. Remove the hoop from the machine, but do not unhoop the stabilizer. Place the fabric piece right inside the sewn dieline.

Reattach the hoop to the machine and continue with the design. A tack down will sew next. This binds the front fabric piece in place for the remainder of the design.

Look at the color change sheet, and stop the machine before sewing "back piece tack down." Remove the hoop from the machine, but do not unhoop the stabilizer. Spray the backside of the back dieline with temporary adhesive, and place it on the back of the embroidery.

Place the hoop back on the machine, and embroider the back piece tack down. Next, all of the inner elements will sew, followed by the satin edges and lace borders.

After embroidering, cut the excess stabilizer away.

The stabilizer's packaging should give instructions for removing the excess. For Vilene, soak the organza pieces for a few moments.

Let the piece air dry, then press using a pressing cloth.

Repeat the previous steps to prepare and embroider five more bell pieces. There should be a total of six.

To assemble to bell ornament, take two of the bell pieces and line them up to one another with the wrong sides together. Hand sew the two pieces together starting at the top point and stitching down along one side to the bottom corner.

Repeat to add the other four bell pieces, carefully adding them one by one by sewing the side edges together.

Finally, sew the first free side to the last to make all the pieces into a loop. This will make the full bell shape. 

Next, cut a 9" length of ribbon. Use a tapestry needle to thread the ribbon through the top holes on just two opposite sides of the bell. Make sure the two ends of the ribbon are sticking out the top of the center hole, and tie the ends in a loop on top of the bell to make the ornament's hanger.

If you'd like, you can even add a jingle bell or bead inside the ornament.