Most embroidery designs are stitched onto fabric, but freestanding lace designs are specially digitized for water-soluble stabilizer. When the stabilizer is removed, beautiful lace remains. 

There are different kinds of water-soluble stabilizer: One is clear and plastic - a brand called Sulky Solvy. The other is soft and fibrous, called Vilene. (These are affiliate links, learn more about affiliate links here)

Both stabilizers will work well, however Vilene is used in this demonstration. Use a size 11 or 75/11 sharp sewing needle. A sharp sewing needle has a smaller, finer point than an embroidery needle. That means it will make smaller holes in the stabilizer. 

Freestanding lace is seen from both sides, so wind a bobbin with the same thread you're using in the needle.

Hoop the stabilizer firmly. Make sure it is nice and tight with no wrinkles. 

Put the hoop onto the machine, and begin sewing the design.

Follow the color change sheet, changing out both the top thread color and the bobbin thread colors as you go. 

When the design is finished, unhoop stabilizer and trim away any excess.

To remove the remaining stabilizer, follow the instructions on your stabilizer's packaging. For Vilene, soak the lace piece until it's fully dissolved.

Once the stabilizer is fully dissolved, remove the bracelet from the water and allow it to air dry. Then press with an iron and pressing cloth. 

These freestanding bracelets have loops on the sides that are meant to be used to extend the bracelet. We recommend hand embroidery floss for a fun and trendy look. It's easy to braid and customize.

Remember to add your floss to both sides!

Once your bracelets are complete, have some fun and accessorize any look!